JET_37944_com.dat  ITER Profile Database;  datasets prepared 
   by Pam Stubberfield,  April 1997

   JET shot 37944 is an ELMy H-mode shot obtained in the new JET pump divertor
   configuration. This pulse (2.5T,2.5MA) is part of a series of rho* scaling
   experiments relevant for ITER. Plasma is 98%D, 2% He3.  The plasma is in a single-
   null X-point configuration with the ion gradB drift pointing towards the X-point.
   6.0MW of 140KV/D and 6.0MW of 80KV/D neutral beam heating is turned on at
   58 secs. The 80KV/D heating stops at 64.2 secs and all beam heating ceases
   at 65.0 secs.

   The dataset files in this subdirectory were prepared from TRANSP run M310 
   taking into account the up-down asymmetry of the plasma, run by Bernard
   Balet on 13 December 1996 on the IBM JAC-2 RS6000 workstation based on
   JET shot 37944 taken on 5 August 1996. 
   All these files have been prepared according to the Standard list of
   Variables and File Format manual by D.Boucher (7 December 1995). Tools
   to produce these files from a TRANSP run were provided by Stan Kaye
   of PPPL. These have only been modified slightly to run on the RS6000
   UNIX workstation and to add 40 secs to all time axes.
   There are 23 1-D Ufiles and 35 2-D Ufiles.  All beam related quantities
   (energy, particle sources, currents etc) have been smoothed to
   suppress Monte-Carlo noise.  In the 2d file the deuterium density is
   stored in NM1 and the helium-3 density in NM2. 

   In the file JET_37944_0d.dat data is given at 60.136 secs.  At that time, there
   is 11.6MW of beam heating and the plasma is in a steady ELMy H-mode phase. 

   Values for kappa and delta in the 0d, 1d and 2d files are from the TRANSP
   output derived from the boundary input definition provided by EFIT.
        kappa = (Zmax-Zmin)/(Rmax-Rmin);   delta = (RGEO - R(Zmax))/a
   XPLIM is from XLOC ; SEPLIM is given by EFIT.
   PLTH is defined by WTH/TAUTH coming directly from TRANSP output and not 
   as defined in the standard list of variables. The 1d files for IP,VSURF 
   and IBOOT have negative values as normal for JET. 
  
   Some comments on this particular TRANSP run M310;
   25ms analysis time resolution; VMEC equilibrium LEVGEO = 6  
   Up-down asymmetric boundary definition obtained from the EFIT program
   No sawteeth events are taken into account in the simulation
   Ti profile  from CX measurements is provided.
   Te profile vs. radius is from LIDAR measurements.
   Ne profile from LIDAR measurements 
   1D total radiation is used in the analysis. 
   Rotation velocity profile from CX measurements is provided.
   2D Zeff profile from CX measurements, Zimp vs time from CX
   Edge ptcl confinement time is set to 1s.
   Bootstrap current on NLBOOT = T ; impose q(0) = 1.1 to start
   Neoclassical beam driven current
 
   The TRANSP simulation in run M310 results in a predicted W_dia within
   0.1 MJ of the measured value.The simulated neutron yield is 6% higher
   than measured value at 60.136 secs.